SENSE
Entrained Air Measuring Device

Problem statement
Industrial processes ranging from food production to paper manufacturing can experience entrained air and foam in process streams, reducing pumping efficiency, disrupting production, and interfering with heat transfer and chemical processing. Antifoam and defoamer chemicals are commonly used to control these effects but can represent a significant material cost. Because feedstock and operating conditions vary, determining an effective dosage requires testing and adjustment. For Applied Material Solutions (AMS), this challenge is particularly important during product-development testing and on-site customer demonstrations. The closest commercial analogue identified for this application is CiDRA’s SONARtrac VF/GVF-100, a non-intrusive, clamp-on passive-sonar system that measures both volumetric flow and entrained air but is specified for pipe diameters ranging from 2 to 60 inches (CiDRA, 2018). CorVera’s HYDRx system also uses passive SONAR processing to measure gas void fraction and offers a clamp-on configuration for flexible hydraulic hoses; however, its rigid-pipe configuration uses sensors ported into the piping through standard fittings rather than a fully external sensor arrangement (CorVera, n.d.; Gysling, 2025). These limitations leave an opportunity for a smaller, fully external system designed specifically for rigid pilot-process piping. The goal of this project is to develop a clamp-on entrained-air and flow-rate sensing system for 1-inch rigid process pipe. Unlike HYDRx, the proposed system will combine gas-void-fraction and flow-rate measurement in a single device while avoiding penetrations or modifications to the process piping. Its smaller size would allow AMS sales personnel to transport, install, and operate the system more easily during customer demonstrations while using less defoamer and process material. It would also support more economical product-development testing by providing the measurements needed to evaluate defoamer performance and dosing requirements at a smaller scale. Compared with existing commercial systems, the proposed design would reduce material consumption, cost, and setup burden for AMS’s intended pilot-scale applications.
Team members

Joshua Gartner – accountant
Jackson Hill – facilitator
Quinn O’Grady – communicator
William Weise – admin
Client
Kamil Adamski
Applied Material Solutions