The Coneheads

CVT Kinematic, Fatigue Improvement

Problem statement

Problem 1: The primary clutch retention bolt must maintain sufficient clamp load while transferring power from the crankshaft to the clutch under high-speed cyclic loading. Polaris testing has shown that the current 10 mm class 10.9 fastener meets fatigue requirements but requires a torque, loosen, and retorque procedure during assembly, as well as a customer retorque after use to maintain the joint [1]. Testing of an 11 mm alternative showed improved preload retention but failure during fatigue testing near the threaded region [1]. Increasing fastener strength also presents material and manufacturing concerns, as research on high-strength steel fasteners has shown that susceptibility to hydrogen embrittlement increases with material strength, with a significant increase observed above approximately 1200 MPa. ASTM F1940 also identifies internal hydrogen embrittlement as a manufacturing concern for high-strength ferrous fasteners exposed to processes such as surface preparation and plating or coating [2]. A clutch retention method is needed that maintains sufficient preload, meets fatigue requirements, and eliminates the need for customer retorque. Problem 2: Polaris snowmobile owners must tune primary clutch flyweights to maintain engine speed near the optimal power range, and this calibration changes with altitude. As elevation increases, decreasing air density reduces engine power, requiring lighter flyweights to maintain the desired engine speed, as described by Aaen in the Clutch Tuning Handbook [1]. Polaris service documentation also demonstrates this relationship, with multiple applications specifying approximately 2 grams less flyweight mass for each 2,000-foot increase in elevation. This is consistent with Aaen’s explanation that flyweight mass directly affects engine operating speed and that Polaris provides weights in small increments for clutch calibration [1]. Currently, adapting to these changes can require riders to replace or modify flyweights, requiring access to the clutch, additional components, tools, and time. A means of adjusting flyweight mass or mass distribution is needed that allows riders to quickly and reliably adapt clutch calibration for changing elevations while minimizing clutch disassembly.

Team members

Frank Torres – accountant
Jacob Wang – facilitator
Mitchell Powell – admin
Stepan Samovyndiak – communicator

Client

Amery Kuhl
Polaris